================================================================================
                                样例使用说明
                             Sample Description
================================================================================
功能描述：
此样例演示了在TIM3输入捕获功能，捕获数据通过DMA传输到变量CC1_Capture中，并通过
串口打印输出。

Function descriptions:
This sample demonstrates the input capture feature in TIM3. The captured data 
is transferred to the variable CC1_Capture using DMA and printed through the UART.
================================================================================
测试环境：
测试用板：PY32F003_STK
MDK版本： 5.28
IAR版本： 9.20
GCC版本： GNU Arm Embedded Toolchain 10.3-2021.10

Test environment:
Test board: PY32F003_STK
MDK Version: 5.28
IAR Version: 9.20
GCC Version: GNU Arm Embedded Toolchain 10.3-2021.10
================================================================================
使用步骤：
1. 下载并运行程序
2. 开始打印数据，未在PA6输入时钟信号，则打印输出的结果为0
3. 在PA6输入时钟信号后，打印数据会根据捕获值进行输出

Example execution steps:
1.Download and run the program.
2.Start printing the data. If there is no clock signal on PA6, the printed 
output will be 0.
3.When a clock signal is input on PA6, the printed data will be output based 
on the captured value.
================================================================================
注意事项：
通过USB转TTL模块连接PC与STK板,STK板与USB转TTL模块的连线方式如下；
@PrintfConfigStart
STK板        USB转TTL模块
PA02(TX)  -->  RX
PA03(RX)  -->  TX
GND       -->  GND
UART配置为波特率115200，数据位8，停止位1，校验位None
@PrintfConfigEnd

Notes:
Connect the PC to the STK board through the USB to TTL module, and the connection
method between the STK board and the USB to TTL module is as follows:
@PrintfConfigStart
STK board USB to TTL module
PA02(TX)  -->  RX
PA03(RX)  -->  TX
GND       -->  GND
UART is configured as BaudRate 115200, data bit 8, stop bit 1, and parity None.
@PrintfConfigEnd
================================================================================